What could cause the strange part on the right? The whole surface should be the same, it’s a 90° wall, so nothing that should look like this. Can’t see anything strange in OrcaSlicer. BambuLab A1 Mini with Creality PLA+
What could cause the strange part on the right? The whole surface should be the same, it’s a 90° wall, so nothing that should look like this. Can’t see anything strange in OrcaSlicer. BambuLab A1 Mini with Creality PLA+
Same height? Check if the vertical axis has a bump/rough spot right there. I’ve found that single vertical point issues tend to mean I need to lubricate the rod again.