Full time nerd

  • 2 Posts
  • 19 Comments
Joined 1 year ago
cake
Cake day: September 29th, 2023

help-circle


  • For good bed adhesion I think I have a couple pieces of advice:

    • Get a PEI bed if you don’t already have one. It makes a world of difference.
    • If that doesn’t stick well, consider getting something like this
    • Make damn sure your bed is level
    • Make sure the Z offset is properly set up
    • If you aren’t already, start by printing PLA, then move on to other filaments once that goes well.
    • Make sure you have proper temperatures for both the hot end and the bed. Normal values for PLA are 210-230 on the hotend and 50-60 on the bed.