I have a keychron v3 (official docs which of course I have looked through) keyboard with a knob. I would like to upgrade the firmware so I can map the knob.

I am using VIA v 3.0.0 AppImage on Manjaro linux. I did the udev thing and it seems to pretty much work.

The factory reset instructions on the keychron website only explain Mac/Windows and I don’t know how to transfer them to Linux. Actually I am not sure if this is even the required procedure to upgrade the firmware but it’s the closet I can find.

What if I use the hardware reset without the software running on the computer?

Any other tips for mapping this keyboard with linux… I am having a hard time generally as it is apparently undocumented. I can’t access their facebook group.

  • imaradio@lemmy.caOPEnglish
    1·
    1 year ago

    So you mean it would have no effect, yes? On restart it will have the same settings and firmware it did prior to pressing the reset button?

    I looked at the QMK docs to see about using it from the terminal. But I am not clear about how to get around the issue of the firmware not being up to date.

    I don’t quite trust various bits and pieces I’ve found about how to use it around the web. Like the configurator page for this device says

    Reset Key: Hold down the key located at K00, commonly programmed as Esc while plugging in the keyboard.

    compared to the keychron docs I linked to in the OP which says

    reset the keyboard by pressing fn + J + Z (for 4 seconds)

    And also describes an actual reset button located under the space bar.

    Why are they different…? It seems like keychron probab knows how to reset their own device. So I wonder if it is a good idea to load anything from this qmk page using methods I don’t understand well because I’d never be able to get myself out of a mess.

    • alteredEnvoy@feddit.ch
      3·
      1 year ago

      Ah I see there is a confusion. The button under the space bar is the flashing mode button, only for flashing new firmware. The factory reset is for when you brick the keyboard.

      When I flash firmwares I use the button under the space bar. I remembered screwed up once , but I forgot which key combo I used to reset it.