Fair enough, I’m talking about big H5 construction screws and impact drivers, so a different use case maybe. Also it turns out when ARRMA uses too much threadlock on their axle set screws you can strip them really easily, and I needed more expensive special hex drivers with tight tolerances to work with them.
Maybe I didn’t use them enough yet, but I bought some Wiha balled hex driver and I haven’t stripped a screw yet, and I use cheap screws.
I also had to dismantle my 3d printer hot end with a lot of weirdly placed screws and it wasn’t even an issue.
Fair enough, I’m talking about big H5 construction screws and impact drivers, so a different use case maybe. Also it turns out when ARRMA uses too much threadlock on their axle set screws you can strip them really easily, and I needed more expensive special hex drivers with tight tolerances to work with them.